Cable Lubrication Tool

CABLE LUBRICATION TOOL

Designed to lubricate throttle and clutch cables

FEATURES:

• Lubricating motorcycle cables prolongs service life and reduces risk of breakage
• Simple operation injects lubricant into cable housing
• Clamps over housing and wire allowing an aerosol can lubricant to be connected
• Once lubricant runs out the far end, the cable is lubricated
• Fast and easy to use on or off the motorcycle
• Suits: Throttle and clutch cables

Instructions:

This is a nice little tool to pressure lube your cables on your bike for smooth operation and longer life. Use your favorite cable lube aerosol can with the little straw the can comes with.
The tool clamps to the cable and the lube is forced in and the cable is lubed quick and easy. See photos below of one in use,
Great to removedirt, grime,water and moisturefrom cables.

Fits 3/16"- 3/8" OD cable diameters , these are the sizes on most bikes.

  
1. Unscrew the clamp Lay the inner cable into the clamp
2. Then push the outer cable into the hole and tighten up the clamp
3. Attach the tube from the aerosol lubrication to the small hole on the side and spray required amount